Cutting with Cut & Emboss Dies
Start with the A Plate. Layer the Embossing Mat over the A Plate. Layer the B Plate over the Embossing Mat.
Layer the Cut & Emboss Die over the B Plate. (Make sure the die is centered over the Embossing Mat below.)
Layer the material to be cut over the Cut & Emboss Die.
Layer a B Plate on top of the material to be cut.
Insert stacked plates into Cricut Cuttlebug™ machine and turn handle to roll plates through.
If you are having difficulty rolling all plates through your machine, you can use a C Plate in place of the Embossing Mat and one B Plate.
Carefully remove excess material from die (only remove material now if you are not going to cut and emboss).
If you find that the die is not cutting entirely through your material, add a few sheets of paper or other material between the Embossing Mat and B Plate