Do you happen to have a cut file you would like to share? Beautiful card!
Cheryl

I'm assuming "cut files" refers to size etc I used to create card. I did these before I discovered CCR; lots of trial and error to get what I wanted, then cut multiples so could recreate the cards. Maybe too much info but I thought more is probably better than less:

The front frame (pg 33 rt)was cut at 4" (height)which produced a width of just short of 5".
The flower (pg 8 top) was cut at 1.25 and 3-D layered on the front frame.
The text from Beyond Bdays was 2.5 ht(about 3" width)and filled with pattern pg 42 rt).

The inside flower border (pg 27 bottom) was cut at 4" and glued with the longer side on top.
The butterflies(pg 12 top) were cut at 1.6" and 1.2. I separated the layers and filled with pattern pg 43 rt - except far rt layer filled with dark teal (pg 46 top rt) and the second from left layer was filled with the light pink (I think) pg 46 bottom 3rd from left.
The bird (pg 29 2nd from rt) was cut twice at 3.25 ht (about 3.5 width). On the first one I changed the pattern to pg 43 rt because I wanted wing to match bird pattern, but that changed the bird (no tail detail in green, etc) so I recut it in original format and used that for the body and the first for the wing.

The strip to create the pop-up(?official term) is glued just off center at 7/8 above the base so the bird's belly is just off the base of the card; the bird sticks out about 1 5/8 so that the wing clears the top inside of the card when opened. It helps to have part of the far wing resting on the pop-up strip.
The labels on the base were cut with spellbinders using rectangles of pattern pg 43 rt and pink.
Flower (pg 8 top) cut at .9 was 3-D glued on label corner.